# Kconfig file for package beep

menuconfig LPKG_USING_BEEP
    bool "beep: Control the buzzer to make beeps at different intervals."
    default n

if LPKG_USING_BEEP

    choice
        prompt "Buzzer type"
        default LPKG_BEEP_ACTIVE_BUZZER
        help
            Select the the Buzzer type

        config LPKG_BEEP_ACTIVE_BUZZER
            bool "Active buzzer"
            select RT_USING_PIN
            select BSP_USING_GPIO

        config LPKG_BEEP_PASSIVE_BUZZER
            bool "Passive buzzer"
            select RT_USING_PWM
            select BSP_USING_PWM
    endchoice

    if LPKG_BEEP_PASSIVE_BUZZER

        config LPKG_BEEP_PWM_DEV_NAME
            string "Setting current PWM device name."
            default "pwm1"

        config LPKG_BEEP_PWM_DEV_CHANNEL
            int "Setting current PWM device channel."
            range 1 4
            default 1

        config LPKG_BEEP_DEFAULT_FREQ
            int "Setting the best frequency(Hz) for buzzer."
            range 100 10000
            default 2700

        if RT_USING_PM
            config LPKG_BEEP_BLOCK_POWER_STOP
                bool "Block the MCU power enter to stop mode on beeping."
                default y

            config LPKG_BEEP_SUPPORT_PM_RUN_FREQ_CHANGE
                bool "Beep with the original frequency at MCU run frequency changed."
                default y
        endif

    endif

    config LPKG_BEEP_USING_MSH_CMD
    bool "Beep the buzzer on console to test."
    default n

    if RT_USING_HEAP
        config LPKG_BEEP_THREAD_STACK_USING_HEAP
        bool "Use heap with the beep thread stack created."
        default y
    endif
endif