add cmu and userid patch

bsp/artinchip/hal/cmu/aic_hal_pll_clk.c

@@ -92,6 +92,34 @@ static int clk_pll_is_enable(struct aic_clk_comm_cfg *comm_cfg)
     return 0;
 }
 
+static void clk_pll_enable_sdm(struct aic_clk_pll_cfg *pll, unsigned long parent_rate, u32 factor_n)
+{
+    u32 reg_val, ppm_max, sdm_amp;
+    u64 sdm_step;
+
+    ppm_max = 1000000 / (factor_n + 1);
+    /* 1% spread */
+    if (ppm_max < PLL_SDM_SPREAD_PPM)
+        sdm_amp = 0;
+    else
+        sdm_amp = PLL_SDM_AMP_MAX -
+                  PLL_SDM_SPREAD_PPM * PLL_SDM_AMP_MAX / ppm_max;
+
+    /* SDM uses triangular wave, 33KHz by default  */
+    sdm_step = (u64)(PLL_SDM_AMP_MAX - sdm_amp) * 2 * PLL_SDM_SPREAD_FREQ;
+    do_div(sdm_step, parent_rate);
+    if (sdm_step > 511)
+        sdm_step = 511;
+
+    reg_val = (1UL << PLL_SDM_EN_BIT) |
+              (2 << PLL_SDM_MODE_BIT) |
+              (sdm_step << PLL_SDM_STEP_BIT) |
+              (3 << PLL_SDM_FREQ_BIT) |
+              (sdm_amp << PLL_SDM_AMP_BIT);
+
+    writel(reg_val, cmu_reg(pll->offset_sdm));
+}
+
 static unsigned long clk_pll_recalc_rate(struct aic_clk_comm_cfg *comm_cfg,
                                          unsigned long parent_rate)
 {
@@ -99,7 +127,7 @@ static unsigned long clk_pll_recalc_rate(struct aic_clk_comm_cfg *comm_cfg,
     u32 factor_n, factor_m, factor_p, fra_in;
     u64 rate, rate_int, rate_fra;
     u8 fra_en = 0;
-    u32 sdm_en = 0;
+    u32 reg_val, sdm_en, sdm_bot;
 
     /* PLL output mux is CLK_24M */
     if (!((readl(cmu_reg(pll->offset_gen)) >> PLL_OUT_MUX) & 0x1))
@@ -126,14 +154,17 @@ static unsigned long clk_pll_recalc_rate(struct aic_clk_comm_cfg *comm_cfg,
     }
 
     if (pll->type == AIC_PLL_SDM) {
-        sdm_en = readl(cmu_reg(pll->offset_sdm));
-        sdm_en >>= 31;
+        reg_val = readl(cmu_reg(pll->offset_sdm));
+        sdm_en = reg_val >> 31;
+        sdm_bot = reg_val & 0xFFFF;
 
-        /* Pll is SDM mode, but SDM is not enable
-         * Create a small deviation, let sys setup again
+        /*
+         * When the PLL is fractional PLL, SDM_EN will also be set to 1,
+         * so SDM_BOT is needed to help determine whether the spreading function
+         * has been enabled.
          */
-        if (sdm_en == 0)
-            rate += 1;
+        if (!sdm_en || !sdm_bot)
+            clk_pll_enable_sdm(pll, parent_rate, factor_n);
     }
 #ifdef FPGA_BOARD_ARTINCHIP
     rate = fpga_board_rate[pll->id];
@@ -192,9 +223,8 @@ static int clk_pll_set_rate(struct aic_clk_comm_cfg *comm_cfg,
     u32 factor_n, factor_m, factor_p, reg_val;
     u64 val, fra_in = 0;
     u8 fra_en, factor_m_en;
+    u32 sdm_en;
     unsigned long vco_rate, pll_vco_min, pll_vco_max;
-    u32 ppm_max, sdm_amp, sdm_en = 0;
-    u64 sdm_step;
     struct aic_clk_pll_cfg *pll = to_clk_pll(comm_cfg);
 
     if (pll->flag & CLK_NO_CHANGE)
@@ -266,32 +296,7 @@ static int clk_pll_set_rate(struct aic_clk_comm_cfg *comm_cfg,
         sdm_en = (1UL << PLL_SDM_EN_BIT) | (2UL << PLL_SDM_MODE_BIT);
         writel(sdm_en, cmu_reg(pll->offset_sdm));
     } else if (pll->type == AIC_PLL_SDM) {
-        sdm_en = readl(cmu_reg(pll->offset_sdm));
-        sdm_en >>= 31;
-
-        ppm_max = 1000000 / (factor_n + 1);
-        /* 1% spread */
-        if (ppm_max < PLL_SDM_SPREAD_PPM)
-            sdm_amp = 0;
-        else
-            sdm_amp = PLL_SDM_AMP_MAX -
-                PLL_SDM_SPREAD_PPM *
-                PLL_SDM_AMP_MAX / ppm_max;
-
-        /* SDM uses triangular wave, 33KHz by default  */
-        sdm_step = (u64)(PLL_SDM_AMP_MAX - sdm_amp) * 2 *
-            PLL_SDM_SPREAD_FREQ;
-        do_div(sdm_step, parent_rate);
-        if (sdm_step > 511)
-            sdm_step = 511;
-
-        reg_val = (1UL << PLL_SDM_EN_BIT) |
-              (2 << PLL_SDM_MODE_BIT) |
-              (sdm_step << PLL_SDM_STEP_BIT) |
-              (3 << PLL_SDM_FREQ_BIT) |
-              (sdm_amp << PLL_SDM_AMP_BIT);
-
-        writel(reg_val, cmu_reg(pll->offset_sdm));
+        clk_pll_enable_sdm(pll, parent_rate, factor_n);
     }
 
     reg_val = readl(cmu_reg(pll->offset_gen));

packages/artinchip/userid/spinand_bare.c

@@ -37,7 +37,7 @@ static int read_userid(struct mtd_dev *mtd, size_t offset, u8 *buf, size_t size)
     if (mtd->erasesize < USERID_MAX_SIZE)
         remain = mtd->erasesize;
     else
-        remain = USERID_MAX_SIZE;
+        remain = size;
     ptr = buf;
 
     while ((remain > 0) && (offset < end)) {

packages/artinchip/userid/spinand_rtt.c

@@ -42,7 +42,7 @@ static int read_userid(struct rt_mtd_nand_device *mtd, size_t offset, u8 *buf, s
     if (erasesize < USERID_MAX_SIZE)
         remain = erasesize;
     else
-        remain = USERID_MAX_SIZE;
+        remain = size;
     ptr = buf;
 
     while ((remain > 0) && (offset < end)) {